RaceFlux 180-Degree Push-Lock Hose End Fitting
Part #
PL-180-XX
Part # PL-180-XX
Push-lock hose end fittings are for use with soft rubber hose or "socketless" hose. Hose and fittings are easy to install: they simply push on with some heat and lubricant, and "lock" in place.
Fittings are black anodized aluminum. Assembled hose is rated for up to 300°F and 150-300 psi (depending on hose size) when used with RaceFlux PH series hoses. Hose clamps are required to ensure the hose does not back off if used at pressures of 10 psi or higher.
These fittings are also useful for converting AN convections to standard rubber hose and vice-versa.
Features and Benefits
- Easy to assemble push-lock style fitting for RaceFlux PH series hose, or other rubber fuel, transmission, and PCV hose.
- Lightweight black anodized aluminum.
- 36% lighter than traditional screw-type line fittings.
Part # | PL-180-XX |
---|---|
Brand | RaceFlux |
Color | Black |
Primary Material | 6061-T6 aluminum |
Finish | Type II Anodized |
Fitting Angle | 180° |
Port A Type | Hose Barb Smooth |
Port B Type | AN Flare Female 37º JIC |
Connection B Gender | N/A |
Maximum Operating Temperature | 500°F (260°C) |
Minimum Operating Temperature | -40°F (-40°C) |
Maximum Operating Pressure | 300 psi (20.68 bar) |
Lock Ring Material | Stainless steel |
Swivel | None on installation only |
Applications | Breather and vent lines Fuel (in-tank) Fuel (outside of tank) Gauge and sensor lines Vacuum lines Other oil water and air systems |
Fluid Compatibility | Air and gas Alcohol Coolants Engine oil Ethanol-based fuels (E85+) Ethanol/gasoline mixtures Gear oil Methanol Nitrous Oxide Racing fuels Transmission fluid Vacuum Water |
Write Your Own Review